Chapter 3: Active Directory Management
Assigning tokens to users
45
Figure 23:
Hardware
token enter serial number
window
c
Enter the hardware token serial number (found on the back of the token)
into the field, and then click
Assign
. The token is now assigned to the
user and you are returned to the User’s Properties window.
d
Give the token to the user. After a token is assigned by the Wizard, its
serial number appears in the Serial Number field of the user’s SafeWord
tab. Continue to “Adding or changing PINs” on page 47.
If you wish to allow users to self-enroll their Hardware token, refer to “Allow-
ing users to self-enroll” on page 75.
Assigning tokens manually (“shortcut” method)
You can directly assign Messaging and Hardware tokens using the token
serial number. This direct assignment method provides a “shortcut” for
quickly assigning tokens. To directly assign a token to a user:
a
Launch ADUC.
b
On the left side of the window, highlight the
Users
folder.
c
Locate the user to whom you will be assigning a token, right-click the
user’s name and select
Properties
, then in the user’s Properties window
click the
SafeWord
tab
.
Tip: If some of your users will share a token, assign the same token serial
number to each user who will share it.