Troubleshooting
|
65
In the paper feed area
If paper is jammed in the paper feed area, follow the next steps to release
the jammed paper.
1.
Using the handle, completely open the front cover.
2.
Carefully remove the paper by pulling in the direction as shown below.
Go to step 7.
If you cannot find the jammed paper, or if there is any resistance
removing the paper, stop pulling, and go to step 3.
3.
Close the front cover.
4.
Pull the tray open.
5.
Remove the jammed paper by gently pulling it straight out as shown
below.
6.
To replace the tray, lower the rear edge, align it with the slot, and slide it
into the printer.
7.
Open the front cover and close it. The printer will resume printing.
•
Do not touch the green surface, the OPC drum or the front of
each toner cartridge, with your hands or any other material. Use
the handle on each cartridge in order to avoid touching this area.
•
Be careful not to scratch the surface of the paper transfer belt.
•
If you leave the front cover open for more than a few minutes,
the OPC drum can be exposed to light. This will cause
damage to the OPC drum. Close the front cover should the
installation need to be halted for any reason.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
