![background image](/i/infiniti/147957/infiniti-g35-sedan-2007/h/infiniti-g35-sedan-2007-107.png)
Instrument brightness control
The instrument brightness control switch
can be operated when the ignition switch
is in the ON position. When the switch is
operated, the dot matrix liquid crystal dis-
play switches to the brightness adjust-
ment mode.
Push the upper switch
q
A
to brighten the
instrument panel lights. The bar
q
1
moves
to the + side. When reaching the
maximum brightness, “MAX” appears on
the display
q
2
.
Push the lower switch
q
B
to dim the in-
strument panel lights. The bar
q
1
moves
to the − side. When reaching the
minimum brightness, “MIN” appears on
the display
q
3
. However, “MIN” does not
appear during the nighttime.
The dot matrix liquid crystal display re-
turns to the normal display under the fol-
lowing conditions:
O
when the instrument brightness con-
trol switch is not operated for more
than 5 seconds.
O
when the side or front of the
switch or
switch on the
right side of the combination meter
panel is pushed.
TURN SIGNAL SWITCH
q
1
Turn signal
Move the lever up or down to signal the
turning direction. When the turn is com-
pleted, the turn signals cancel automati-
cally.
q
2
Lane change signal
To indicate a lane change, move the lever
up or down to the point where lights
begin flashing.
FOG LIGHT SWITCH
To turn the fog lights on, turn the head-
light switch to the
position, then
turn the switch to the
position. To
turn them off, turn the switch to the OFF
position.
The headlights must be on for the fog
lights to operate.
SIC3271
SIC3272
Instruments and controls
2-39
w
06.7.27/V36-D
X