![background image](/i/infiniti/147957/infiniti-g35-sedan-2007/h/infiniti-g35-sedan-2007-158.png)
The seat synchronization function oper-
ates under the following conditions:
O
The ignition switch is in the ON posi-
tion.
O
The selector lever is in the P (Park) po-
sition
(Automatic
Transmission
models) or the parking brake is ap-
plied (Manual Transmission models).
If the outside mirrors or the steering
wheel reaches its maximum adjustment,
the function is automatically disabled. Re-
start the function by selecting a previ-
ously stored seat memory position using
the memory switches (1 or 2). An Intelli-
gent Key that was previously linked to the
stored seat memory can also be used to
restart the function.
If a seat position was not previously
stored in the seat memory, restart the
function by adjusting the steering wheel
and outside mirrors manually for your
best driving position and then drive the
vehicle above 4 MPH (7 km/h).
Cancel or activate seat
synchronization function
For Automatic Transmission models:
The selector lever must be in the P (park)
position with the ignition switch in the
OFF position.
For Manual Transmission models:
The parking brake must be applied with
the ignition switch in the OFF position.
The seat synchronization function can be
activated or canceled by pressing and
holding the SET switch for more than 10
seconds while the ignition switch is in the
OFF position.
Activating or canceling the seat synchro-
nization function using the SET switch
also activates or cancels the entry/exit
function.
The indicator lights on the memory
switches (1 and 2) will blink once when the
function is canceled, and the indicator
lights will blink twice when the function is
activated. Note that the indicator lights may
illuminate after 5 seconds while holding the
SET switch. This indicates readiness for
linking the Intelligent Key to a stored
memory position. Keep the SET switch
pressed for more than 10 seconds to turn
on or off the seat synchronization function.
For Automatic Transmission models, the
seat synchronization function can also be
activated if both the
0
Lift Steering Wheel
on Exit
0
key and
0
Slide Driver Seat Back
on Exit
0
key are turned to ON or canceled
if either the “
Lift Steering Wheel on Exit
”
key or “
Slide Driver Seat Back on Exit
” key
or both are turned to OFF in the “Comfort
& Conv.” settings. See “VEHICLE INFOR-
MATION AND SETTINGS” in the “4.
Monitor, climate, audio, phone and voice
recognition systems.
MEMORY STORAGE
Two positions for the driver’s seat,
steering column and outside mirrors can
be stored in the automatic drive posi-
tioner memory. Follow these procedures
to use the memory system.
1.
Automatic transmission models:
Move the selector lever to the P (Park)
position.
Manual transmission models:
Move the shift lever to the 1st or R (Re-
verse) position and the parking brake
is applied.
3-28
Pre-driving checks and adjustments
w
07.2.6/V36-D
X