![background image](/i/infiniti/147957/infiniti-g35-sedan-2007/h/infiniti-g35-sedan-2007-087.png)
This light also comes on when the AFS is
turned off by pushing the OFF side of the
AFS switch.
If the AFS indicator light blinks, it may in-
dicate the AFS is not functioning properly.
Have the system checked by an INFINITI
dealer.
See “Adaptive Front lighting System
(AFS)” later in this section.
Automatic transmission
position indicator light
When the ignition switch is pushed to the
ON position, the indicator shows the au-
tomatic selector shift position. See
“Driving with automatic transmission” in
the “5. Starting and driving” section.
Front passenger air bag
status light
The front passenger air bag status light
(
) will be lit and the passenger front
air bag will be OFF depending on how the
front passenger seat is being used.
For front passenger air bag status light
operation, see “INFINITI advanced air bag
system” in the “1. Safety — Seats, seat
belts and supplemental restraint system”
section of this manual.
High beam indicator light
(Blue)
This light comes on when the headlight
high beam is on and goes out when the
low beam is selected.
Malfunction Indicator Light
(MIL)
If the malfunction indicator light comes
on steady or blinks while the engine is
running, it may indicate a potential emis-
sion control malfunction.
The malfunction indicator light may also
come on steady if the fuel-filler cap is
loose or missing, or if the vehicle runs out
of fuel. Check to make sure the fuel-filler
cap is installed and closed tightly, and
that the vehicle has at least 3 US gallons
(14 liters) of fuel in the fuel tank.
After a few driving trips, the
light
should turn off if no other potential emis-
sion control system malfunction exists.
If this indicator light remains on for 20
seconds and then blinks for 10 seconds
when the engine is not running, it indi-
cates that the vehicle is not ready for an
emission
control
system
inspection/
maintenance test. See “Readiness for
inspection/maintenance (I/M) test” in the
“9. Technical and consumer information”
section of this manual.
Operation
The malfunction indicator light will come
on in one of two ways:
O
Malfunction indicator light on steady
— An emission control system mal-
function has been detected. Check the
fuel-filler cap. If the fuel-filler cap is
loose or missing, tighten or install the
cap and continue to drive the vehicle.
The
light should turn off after a
few driving trips. If the
light does
not turn off after a few driving trips,
have the vehicle inspected by an
INFINITI dealer. You do not need to
have your vehicle towed to the dealer.
O
Malfunction indicator light blinking —
An engine misfire has been detected
which may damage the emission con-
trol system.
To reduce or avoid emission control
system damage:
a) Do not drive at speeds above 45
MPH (72 km/h).
b) Avoid hard acceleration or decel-
eration.
Instruments and controls
2-19
w
06.9.20/V36-D
X