![background image](/i/infiniti/147957/infiniti-g35-sedan-2007/h/infiniti-g35-sedan-2007-388.png)
Use the following steps to mount the li-
cense plate:
Before mounting the license plate, con-
firm that the following parts are enclosed
in the plastic bag.
Only use the recommended mounting po-
sition or Intelligent Cruise Control (ICC)
sensor obstruction (if so equipped) may
result.
O
License plate bracket
O
J-nut x 2
O
Screw x 2
O
Screw grommet x 2
1. Temporarily place the license plate
bracket while aligning the lines
q
A
be-
hind the top of the front bumper
opening with part
q
B
of the rear sur-
face of the license plate bracket.
2. To determine where to drill the hole,
mark
along
both
sides
of
the
mounting hole by using a felt-tip pen.
3. Remove the license plate bracket and
connect the arcs to form ovals. Mark
the point in the center of each oval.
These are the pilot drilling locations.
4. Carefully drill two pilot holes using a
STI0496
INSTALLING FRONT LICENSE PLATE
9-12
Technical and consumer information
w
06.7.27/V36-D
X