![background image](/i/infiniti/147957/infiniti-g35-sedan-2007/h/infiniti-g35-sedan-2007-041.png)
ously injure or kill your child.
O
INFINITI recommends that child re-
straints be installed in the rear seat.
However, if you must install a forward
facing child restraint in the front pas-
senger seat, move the passenger seat to
the rearmost position. Also, be sure the
front passenger air bag status light is il-
luminated to indicate the passenger air
bag is OFF. See “Front passenger air bag
and status light” in this section for de-
tails.
O
The three-point seat belt in your vehicle
is equipped with an automatic locking
mode retractor which must be used
when installing a child restraint.
O
Failure to use the retractor’s locking
mode will result in the child restraint not
being properly secured. The restraint
could tip over or otherwise be unsecured
and cause injury to the child in a sudden
stop or collision.
O
A child restraint with a top tether strap
should not be used in the front pas-
senger seat.
The instructions in this section apply to
child restraint installation using the ve-
hicle seat belts in the rear seat or the
front passenger seat.
Front-facing
Follow these steps to install a front-facing
child restraint using the vehicle seat belt
in the rear seat or in the front passenger
seat:
1. If you must install a child restraint in
the front seat, it should be placed in a
front-facing direction only. Move the
seat to the rearmost position. Child re-
straints for infants must be used in the
rear-facing direction and therefore
must not be used in the front seat.
2. Position the child restraint on the
SSS0640
Front facing (front passenger seat) — step 1
Safety — Seats, seat belts and supplemental restraint system
1-25
w
06.7.27/V36-D
X