![background image](/i/infiniti/147957/infiniti-g35-sedan-2007/h/infiniti-g35-sedan-2007-046.png)
5. Remove any additional slack from the
child restraint; press downward and
rearward firmly in the center of the
child restraint with your hand to com-
press the vehicle seat cushion and
seatback while pulling up on the seat
belt.
6. Before placing the child in the child
restraint, hold the child restraint near
the seat belt path and use force to
push the child restraint from side to
side, and tug it forward to make sure
that it is securely held in place. It
should not move more than 1 in (25
mm). If it does move more than 1 in
(25 mm), pull again on the shoulder
belt to further tighten the child re-
straint. If you are unable to properly
secure the restraint, move the re-
straint to another rear seating position
and try again, or try a different child
restraint. Not all child restraints fit in
all types of vehicles.
7. Check that the retractor is in the auto-
matic locking mode by trying to pull
more seat belt out of the retractor. If
you cannot pull any more seat belt
webbing out of the retractor, the re-
tractor is in the automatic locking
mode.
8. Check to make sure that the child re-
straint is properly secured prior to
each use. If the belt is not locked, re-
peat steps 3 through 6.
After the child restraint is removed and
the seat belt fully retracted, the automatic
locking mode (child restraint mode) is
canceled.
SSS0657
Rear facing — step 5
SSS0658
Rear facing — step 6
1-30
Safety — Seats, seat belts and supplemental restraint system
w
06.7.27/V36-D
X