![background image](/i/infiniti/147957/infiniti-g35-sedan-2007/h/infiniti-g35-sedan-2007-159.png)
2. Push the ignition switch to the ON po-
sition.
3. Adjust the driver’s seat, steering
column and outside mirrors to the de-
sired positions by manually operating
each adjusting switch. For additional
information,
see
“Seats”
in
the
“1. Safety — Seats, seat belts and
supplemental restraint system” sec-
tion and “Tilting telescopic steering
column” and “Outside mirrors” earlier
in this section.
4. Push the SET switch and, within 5 sec-
onds, push the memory switch (1 or 2)
fully for at least 1 second.
The indicator light for the pushed
memory switch will stay on for ap-
proximately 5 seconds after pushing
the switch.
If memory is stored in the same
memory switch, the previous memory
will be deleted.
For manual transmission models, the
memory positions can be stored even
when the engine is running. In this case,
move the shift lever to the N (Neutral) po-
sition and apply the parking brake. Then,
repeat steps 2 through 4.
Linking Intelligent Key to a stored
memory position
The Intelligent Key can be linked to a
stored memory position with the following
procedure.
1. Follow the steps for storing a memory
position.
2. While the indicator light for the
memory switch being set is illumi-
nated for 5 seconds, push the
button on the Intelligent Key. If
the indicator light blinks, the Intelli-
gent Key is linked to that memory set-
ting.
Push the ignition switch to the OFF posi-
tion and press the
button on the In-
telligent Key. The driver’s seat, steering
wheel and outside mirrors will move to
the memorized position.
Confirming memory storage
O
Push the ignition switch to the ON po-
sition and push the SET switch. If the
main memory has not been stored, the
indicator light will come on for ap-
proximately 0.5 seconds. When the
memory has stored in position, the in-
dicator light will stay on for approxi-
mately 5 seconds.
O
If the battery cable is disconnected, or
if the fuse opens, the memory will be
canceled. In this case, reset the de-
sired position using the previous pro-
cedure.
O
If optional Intelligent Keys are added
to your vehicle, the memory storage
procedure to switch 1 or 2 and linking
Intelligent Key procedure to a stored
memory position should be performed
again for each Intelligent Key. For ad-
ditional Intelligent Key information,
see “Key (Intelligent Key)” earlier in
this section.
Selecting the memorized position
1.
Automatic transmission models:
Move the selector lever to the P (Park)
position.
Manual transmission models:
Move the shift lever to the 1st or R (Re-
verse) position and apply the parking
brake.
2. Use one of the following methods to
move the driver’s seat, the outside
mirrors and the steering wheel.
Pre-driving checks and adjustments
3-29
w
07.2.6/V36-D
X