![background image](/i/infiniti/147957/infiniti-g35-sedan-2007/h/infiniti-g35-sedan-2007-044.png)
straint. Not all child restraints fit in all
types of vehicles.
9. Check that the retractor is in the auto-
matic locking mode by trying to pull
more seat belt out of the retractor. If
you cannot pull any more belt web-
bing out of the retractor, the retractor
is in the automatic locking mode.
10. Check to make sure the child restraint
is properly secured prior to each use.
If the seat belt is not locked, repeat
steps 3 through 8.
11. If the child restraint is installed in the
front passenger seat, push the igni-
tion switch to the ON position. The
front passenger air bag status light
should illuminate. If this light is
not illuminated, see “Front passenger
air bag and status light” in this sec-
tion.
Move the child restraint to an-
other seating position.
Have the
system checked by an INFINITI dealer.
After the child restraint is removed and
the seat belt is fully retracted, the auto-
matic locking mode (child restraint mode)
is canceled.
Rear-facing
Follow these steps to install a rear-facing
child restraint using the vehicle seat belt
in the rear seat:
1.
Child restraints for infants must be
used in the rear-facing direction and
therefore must not be used in the front
seat.
Position the child restraint on
the seat. Always follow the restraint
manufacturer’s instructions.
SSS0676
Front facing — step 11
SSS0100
1-28
Safety — Seats, seat belts and supplemental restraint system
w
06.7.27/V36-D
X