![background image](/i/infiniti/147957/infiniti-g35-sedan-2007/h/infiniti-g35-sedan-2007-127.png)
HomeLink Universal Transceiver provides
a convenient way to consolidate the func-
tions of up to three individual hand-held
transmitters into one built-in device.
HomeLink Universal Transceiver:
O
Will operate most Radio Frequency
(RF) devices such as garage doors,
gates, home and office lighting, entry
door locks and security systems.
O
Is powered by your vehicle’s battery.
No separate batteries are required. If
the vehicle’s battery is discharged or
is disconnected, HomeLink will retain
all programming.
Once HomeLink Universal Transceiver is
programmed, retain the original trans-
mitter for future programming procedures
(Example: new vehicle purchases). Upon
sale of the vehicle, the programmed
HomeLink Universal Transceiver buttons
should be erased for security purposes.
For additional information, refer to “Pro-
gramming HomeLink ” later in this sec-
tion.
WARNING
O
Do not use HomeLink Universal Trans-
ceiver with any garage door opener that
lacks safety stop and reverse features as
required by federal safety standards.
(These standards became effective for
opener models manufactured after April
1, 1982). A garage door opener which
cannot detect an object in the path of a
closing garage door and then automati-
cally stop and reverse, does not meet
current federal safety standards. Using a
garage door opener without these fea-
tures increases the risk of serious injury
or death.
O
During programming procedure, your
garage door or security gate may open
or close. Make sure that people and ob-
jects are clear of the garage door, gate,
etc. that you are programming.
O
Your vehicle’s engine should be turned
off while programming HomeLink Uni-
versal Transceiver.
PROGRAMMING HomeLink
To program your HomeLink Transceiver
to operate a garage door, gate, or entry
door opener, home or office lighting, you
need to be at the same location as the
device. Note: Garage door openers (manu-
factured after 1996) have “rolling code
protection”. To program a garage door
opener equipped with “rolling code pro-
tection”; you will need to use a ladder to
get up to the garage door opener motor to
be able to access the “smart or learn”
program button.
HomeLink UNIVERSAL TRANSCEIVER
Instruments and controls
2-59
w
06.7.27/V36-D
X