![background image](/i/infiniti/147957/infiniti-g35-sedan-2007/h/infiniti-g35-sedan-2007-160.png)
O
Turn the ignition switch to the ON
position and push the memory
switch (1 or 2) fully for at least 1
second.
O
Within 45 seconds of opening the
driver’s door, push the memory
switch (1 or 2) fully for at least 1
second.
The driver’s seat, steering column and
outside mirrors will move to the
memorized position with the indicator
light flashing, and then the light will
stay on for approximately 5 seconds.
For manual transmission models, the
memory positions can be selected even
when the engine is running. In this case,
move the shift lever to the N (Neutral) po-
sition and apply the parking brake. Then,
perform step 2.
SYSTEM OPERATION
The automatic drive positioner system will
not work or will stop operating under the
following conditions:
O
When the vehicle speed is above 4
MPH (7 km/h).
O
When the adjusting switch for the driv-
er’s seat and steering column is
turned on while the automatic drive
positioner is operating.
O
When the memory switch 1 or 2 is not
pushed for at least 1 second.
O
When the seat, steering column and
outside mirrors have already been
moved to the memorized position.
O
When no position is stored in the
memory switch.
O
When the parking brake is released. —
MT models
O
When the speed is above 4 MPH (7
km/h) while the parking brake is ap-
plied. — MT models
To restart the drive positioner system,
move the parking brake to off and on.
O
When the engine is started while mov-
ing the automatic drive positioner.
O
When the AT selector lever is moved
from the P (Park) position to any other
position. (However, it will not be can-
celed if the switch is pushed while the
seat and steering column are returning
to the previous positions (entry/exit
function).)
O
When the driver’s door remains open
for more than 45 seconds and the igni-
tion switch is not in the ON position.
O
The seat synchronization function is
automatically disabled if the outside
mirrors or steering wheel reaches its
maximum adjustment.
O
The seat synchronization function will
not move if the seat is adjusted over
one of the following maximum thresh-
olds:
— Seat sliding: 3.0 inch (76 mm)
— Seatback reclining: 9.1 degrees
— Seat lifer (rear side): 0.8 inch (20
mm)
3-30
Pre-driving checks and adjustments
w
07.2.6/V36-D
X