![background image](/i/infiniti/147957/infiniti-g35-sedan-2007/h/infiniti-g35-sedan-2007-372.png)
CHANGING WHEELS AND TIRES
Tire rotation (except 18-inch tire
models)
INFINITI recommends rotating the tires
every 7,500 miles (12,000 km), except
18-in tire models. See “Flat tire” in the
“6. In case of emergency” section for
tire replacing procedures.
As soon as possible, tighten the wheel
nuts to the specified torque with a
torque wrench.
Wheel nut tightening torque:
80 ft-lb (108 N
z
m)
The wheel nuts must be kept tightened
to the specification at all times. It is rec-
ommended that wheel nuts be tightened
to the specification at each tire rotation
interval.
WARNING
O
After rotating the tires, check and
adjust the tire pressure.
O
Retighten the wheel nuts when
the vehicle has been driven for
600 miles (1,000 km) (also in
cases of a flat tire, etc.).
O
Do not include the T-type spare
tire or any other small size spare
tire in the tire rotation.
O
For additional information re-
garding tires, refer to “Important
Tire Safety Information” (US) or
“Tire
Safety
Information”
(Canada) in the Warranty Informa-
tion Booklet.
Tire rotation (18-inch tire models)
Tires cannot be rotated on this vehicle,
as front tires are a different size from
rear tires and the direction of the wheel
rotation is fixed for each tire.
A pin is on the front brake rotor to pre-
vent the rear wheels from being in-
stalled in place of the front wheels. The
spare tire can be installed in place of
the front and rear wheels. When install-
ing the spare tire in the front wheel, the
hole in the spare tire wheel must be
aligned with the pin on the brake rotor.
WARNING
O
Retighten the wheel nuts when
the vehicle has been driven for
600 miles (1,000 km) (also in
cases of a flat tire, etc.).
O
For additional information re-
garding tires, refer to “Important
Tire Safety Information” (US) or
“Tire
Safety
Information”
(Canada) in the Warranty Informa-
tion Booklet.
SDI1662
8-36
Maintenance and do-it-yourself
w
06.7.27/V36-D
X