![background image](/i/infiniti/147957/infiniti-g35-sedan-2007/h/infiniti-g35-sedan-2007-129.png)
second person to assist when performing
this step.
7. Quickly (within 30 seconds of pushing
and releasing the garage door opener
training button) and firmly push and
release the HomeLink button you’ve
just programmed. Push and release
the HomeLink
button up to three
times to complete the training.
8. Your HomeLink button should now be
programmed. To program the re-
maining HomeLink buttons for addi-
tional door or gate openers, follow
steps 2 through 8 only.
NOTE:
Do not repeat step 1 unless you want to
“clear”
all
previously
programmed
HomeLink buttons.
If you have any questions or are having
difficulty programming your HomeLink
buttons, please refer to the HomeLink
web site at: www.homelink.com or call
1-800-355-3515.
PROGRAMMING HomeLink FOR
CANADIAN CUSTOMERS
Prior to 1992, D.O.C. regulations required
hand-held transmitters to stop transmit-
ting after 2 seconds. To program your
hand-held transmitter to HomeLink , con-
tinue to push and hold the HomeLink
button (note steps 2 through 4 under
“Programming HomeLink ”) while you
push and re-push (“cycle”) your hand-
held transmitter every 2 seconds until the
indicator light flashes rapidly (indicating
successful programming).
NOTE:
If programming a garage door opener, etc.,
it is advised to unplug the device during
the “cycling” process to prevent possible
damage to the garage door opener compo-
nents.
OPERATING THE HomeLink
UNIVERSAL TRANSCEIVER
HomeLink
Universal Transceiver (once
programmed) may now be used to acti-
vate the garage door, etc. To operate,
simply push the appropriate programmed
HomeLink Universal Transceiver button.
The red indicator light will illuminate
while the signal is being transmitted.
PROGRAMMING TROUBLE-
DIAGNOSIS
If HomeLink does not quickly learn the
hand-held transmitter information:
O
replace the hand-held transmitter bat-
teries with new batteries.
O
position the hand-held transmitter
with its battery area facing away from
the HomeLink surface.
O
push and hold both the HomeLink
and hand-held transmitter buttons
without interruption.
O
position the hand-held transmitter 2
to 5 in (50 to 127 mm) away from the
HomeLink surface. Hold the transmit-
ter in that position for up to 15 sec-
onds. If HomeLink
is not pro-
grammed within that time, try holding
the transmitter in another position -
keeping the indicator light in view at
all times.
If you continue to have programming diffi-
culties, please contact the INFINITI Con-
sumer Affairs Department. The phone
numbers are located in the Foreword of
this Owner’s Manual.
Instruments and controls
2-61
w
06.7.27/V36-D
X