Chapter 14 Mirroring
GS3700/XGS3700 Series User’s Guide
132
14.1.2 Remote Port Mirroring
Use this screen to create a remote port mirroring (RMirror) VLAN through which the mirrored traffic
is forwarded.
Click the RMirror link in the Basic Setting > Mirroring screen. The following screen opens.
Figure 81
Advanced Application > Mirroring > RMirror
The following table describes the labels in this screen.
14.1.3 Source
Use this screen to configure the reflector port and specify the traffic flow to be copied to the
monitor port when the Switch is the source device in remote port mirroring.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Table 55
Advanced Application > Mirroring (continued)
LABEL
DESCRIPTION
Table 56
Advanced Application > Mirroring > RMirror
LABEL
DESCRIPTION
Active
Select the option to enable the VLAN.
RMirror VLAN ID
Specify the ID number of remote port mirroring (RMirror) VLAN.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the nonvolatile memory when you are done
configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
VLAN
This field displays the ID number of the RMirror VLAN. Click on the VLAN ID number to
change the settings.
Active
This field displays whether the VLAN is enabled or not.
Delete
Check the rule(s) that you want to remove in the Delete column and then click the
Delete button.
Cancel
Click Cancel to begin configuring this screen afresh.