Chapter 43 Access Control
GS3700/XGS3700 Series User’s Guide
358
Figure 247
Management > Access Control > SNMP
The following table describes the labels in this screen.
Table 193
Management > Access Control > SNMP
LABEL
DESCRIPTION
General Setting
Use this section to specify the SNMP version and community (password) values.
Version
Select the SNMP version for the Switch. The SNMP version on the Switch must match the
version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or
both (v3v2c).
Note: SNMP version 2c is backwards compatible with SNMP version 1.
Get Community
Enter the Get Community string, which is the password for the incoming Get- and
GetNext- requests from the management station.
The Get Community string is only used by SNMP managers using SNMP version 2c or
lower.
Set Community
Enter the Set Community string, which is the password for the incoming Set- requests
from the management station.
The Set Community string is only used by SNMP managers using SNMP version 2c or
lower.
Trap Community
Enter the Trap Community string, which is the password sent with each trap to the
SNMP manager.
The Trap Community string is only used by SNMP managers using SNMP version 2c or
lower.
Trap Destination
Use this section to configure where to send SNMP traps from the Switch.
Version
Specify the version of the SNMP trap messages.
IP
Enter the IP addresses of up to four managers to send your SNMP traps to.
Port
Enter the port number upon which the manager listens for SNMP traps.
Username
Enter the username to be sent to the SNMP manager along with the SNMP v3 trap.
Note: This username must match an existing account on the Switch (configured in the
Management > Access Control > SNMP > User
screen).