Chapter 6 Basic Setting
GS3700/XGS3700 Series User’s Guide
59
The following table describes the labels in this screen.
Table 12
Basic Setting > IP Setup
LABEL
DESCRIPTION
Default Gateway Type the IP address of the default outgoing gateway in dotted decimal notation, for
example 192.168.1.254.
Domain Name
Server
DNS (Domain Name System) is for mapping a domain name to its corresponding IP address
and vice versa. Enter a domain name server IP address in order to be able to use a domain
name instead of an IP address.
Default
Management
Specify which traffic flow (In-Band or Out-of-band) the Switch is to send packets
originating from itself (such as SNMP traps) or packets with unknown source.
Select Out-of-band to have the Switch send the packets to the management port labelled
MGMT. This means that device(s) connected to the other port(s) do not receive these
packets.
Select In-Band to have the Switch send the packets to all ports except the management
port (labelled MGMT) to which connected device(s) do not receive these packets.
Management IP Address
Use these fields to set the settings for the out-of-band management port.
IP Address
Enter the out-of-band management IP address of your Switch in dotted decimal notation.
For example, 192.168.0.1.
IP Subnet
Mask
Enter the IP subnet mask of your Switch in dotted decimal notation, for example,
255.255.255.0.
Default
Gateway
Enter the IP address of the default outgoing gateway in dotted decimal notation, for
example, 192.168.0.254
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to reset the fields to your previous configuration.
IP Interface
Use these fields to create or edit IP routing domains on the Switch.
IP Address
Enter the IP address of your Switch in dotted decimal notation, for example, 192.168.1.1.
This is the IP address of the Switch in an IP routing domain.
IP Subnet
Mask
Enter the IP subnet mask of an IP routing domain in dotted decimal notation, for example,
255.255.255.0.
VID
Enter the VLAN identification number to which an IP routing domain belongs.
Add
Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to reset the fields to your previous configuration.
Index
This field displays the index number of an entry.
IP Address
This field displays IP address of the Switch in the IP domain.
IP Subnet Mask
This field displays the subnet mask of the Switch in the IP domain.
VID
This field displays the VLAN identification number of the IP domain on the Switch.
Delete
Click Delete to remove the selected entry from the summary table.
Note: Deleting all IP subnets locks you out of the Switch.
Cancel Click
Cancel to clear the Delete check boxes.