Chapter 34 Link Layer Discovery Protocol (LLDP)
GS3700/XGS3700 Series User’s Guide
289
34.6.1 LLDP Configuration Basic TLV Setting
Use this screen to configure Basic TLV settings. Click Advanced Application > LLDP > LLDP
Configuration > Basic TLV Setting to display the screen as shown next.
Figure 187
Advanced Application > LLDP > LLDP Configuration> Basic TLV Setting
Admin Status
Select whether LLDP transmission and/or reception is allowed on this port.
•
Disable - not allowed
•
Tx-Only - transmit only
•
Rx-Only - receive only
•
Tx-Rx - transmit and receive
Notification
Select whether LLDP notification is enabled on this port.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Table 149
Advanced Application > LLDP > LLDP Configuration
LABEL
DESCRIPTION