Chapter 34 Link Layer Discovery Protocol (LLDP)
GS3700/XGS3700 Series User’s Guide
292
Figure 189
Advanced Application > LLDP > LLDP-MED Configuration
The following table describes the labels in this screen.
34.8 LLDP-MED Network Policy
Click Advanced Application > LLDP > LLDP-MED Network Policy to display the screen as
shown next.
Table 152
Advanced Application > LLDP > LLDP-MED Configuration
LABEL
DESCRIPTION
Port
This displays the port number on which you’re configuring LLDP-MED. Select * to
configure all ports simultaneously.
Notification
Topology
Change
Select to enable LLDP-MED topology change traps on this port.
MED TLV Setting
Location
Select to enable transmitting LLDP-MED location TLV.
Network Policy
Select to enable transmitting LLDP-MED Network Policy TLV.
Apply
Click Apply to save the changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.