Chapter 6 Basic Setting
GS3700/XGS3700 Series User’s Guide
79
The following table describes the labels in this screen.
6.9.11 DHCPv6 Client Setup
Use this screen to configure the Switch’s DHCP settings when it is acting as a DHCPv6 client. Click
the link next to IPv6 Neighbor Setup in the IPv6 Configuration screen to display the screen as
shown next.
Table 27
Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Setup
LABEL
DESCRIPTION
Interface Type
Select the type of IPv6 interface for which you want to configure. The Switch supports
the VLAN interface type for IPv6 at the time of writing.
Interface ID
Specify a unique identification number (from 1 to 4094) for the interface.
Note: A static IPv6 neighbor entry displays in the
Management > Neighbor Table
screen only when the interface ID is also created in the
Basic Setup > Interface
Setup
screen.
Note: To have IPv6 function properly, you should configure a static VLAN with the same
ID number in the
Advanced Setup > VLAN
screens.
Neighbor Address
Specify the IPv6 address of the neighboring device which can be reached through the
interface.
MAC
Specify the MAC address of the neighboring device which can be reached through the
interface.
Add
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the nonvolatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Clear
Click Clear to reset the fields to the factory defaults.
Index
This is the interface index number. Click on an index number to change the settings.
Interface
This is the name of the IPv6 interface you created.
Neighbor Address
This field displays the IPv6 address of the neighboring device which can be reached
through the interface
MAC
This field displays the MAC address of the neighboring device which can be reached
through the interface.
Delete
Check the entry(ies) that you want to remove in the Delete column and then click
Delete to remove the selected entry(ies) from the summary table.
Cancel
Click Cancel to clear the Delete check boxes.