Chapter 22 Multicast
GS3700/XGS3700 Series User’s Guide
186
22.4 IPv6 Multicast Status
Click Advanced Application > Multicast > IPv6 Multicast to display the screen as shown. This
screen shows the IPv6 multicast group information. See
for more
information on multicasting.
Figure 115
Advanced Application > Multicast > IPv6 Multicast
The following table describes the labels in this screen.
22.4.1 MLD Snooping-proxy
Click the MLD Snooping-proxy link in the Advanced Application > Multicast > IPv6 Multicast
screen to display the screen as shown. See
multicasting.
Figure 116
Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy
The following table describes the labels in this screen.
Table 88
Advanced Application > Multicast > IPv6 Multicast
LABEL
DESCRIPTION
Index
This is the index number of the entry.
VID
This field displays the multicast VLAN ID.
Port
This field displays the port number that belongs to the multicast group.
Multicast Group
This field displays IP multicast group addresses.
Group Timeout
This field displays the time (in seconds) that elapses before the Switch removes an MLD
group membership entry if it does not receive report messages from the port.
Table 89
Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy
LABEL
DESCRIPTION
MLD Snooping-
proxy
Use these settings to configure MLD snooping-proxy.
Active
Select Active to enable MLD snooping-proxy on the Switch to minimize MLD control
messages and allow better network performance.
802.1p Priority
Select a priority level (0-7) to which the Switch changes the priority in outgoing MLD
messages.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.