Chapter 6 Basic Setting
GS3700/XGS3700 Series User’s Guide
58
6.5 IP Setup
Use the IP Setup screen to configure the default gateway device, the default domain name server
and add IP domains.
6.5.1 IP Interfaces
The Switch needs an IP address for it to be managed over the network. The factory default IP
address is 192.168.1.1. The subnet mask specifies the network number portion of an IP address.
The factory default subnet mask is 255.255.255.0.
On the Switch, an IP address is not bound to any physical ports. Since each IP address on the
Switch must be in a separate subnet, the configured IP address is also known as IP interface (or
routing domain). In addition, this allows routing between subnets based on the IP address without
additional routers.
You can configure multiple routing domains on the same VLAN as long as the IP address ranges for
the domains do not overlap. To change the IP address of the Switch in a routing domain, simply add
a new routing domain entry with a different IP address in the same subnet.
You can configure up to 128 IP domains which are used to access and manage the Switch from the
ports belonging to the pre-defined VLAN(s).
Note: You must configure a VLAN first.
Figure 25
Basic Setting > IP Setup