Chapter 41 ARP Setup
GS3700/XGS3700 Series User’s Guide
342
41.2.2 Static ARP
Use this screen to create static ARP entries that will display in the Management > ARP Table
screen and will not age out. Click the link next to Static ARP in the IP Application > ARP Setup
screen to display the screen as shown.
Figure 237
IP Application > ARP Setup > Static ARP
The following table describes the related labels in this screen.
Table 181
IP Application > ARP Setup > Static ARP
LABEL
DESCRIPTION
Active
Select this check box to activate your rule. You may temporarily deactivate a rule without
deleting it by clearing this check box.
Name
Enter a descriptive name (up to 32 printable ASCII characters) for identification purposes.
IP Address
Enter the IP address of a device connected to a Switch port with the corresponding MAC
address below.
MAC Address
Enter the MAC address of the device with the corresponding IP address above.
VID
Enter the ID number of VLAN to which the device belongs.
Port
Enter the number of port to which the device connects.
Add
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Clear Click
Clear to set the above fields back to the factory defaults.
Index
This field displays the index number of an entry. Click an index number to change the
settings.
Active
This field displays Yes when the entry is activated and NO when it is deactivated.
Name
This field displays the descriptive name for this entry. This is for identification purposes
only.
IP Address
This is the IP address of a device connected to a Switch port with the corresponding MAC
address below.