Chapter 24 IP Source Guard
GS3700/XGS3700 Series User’s Guide
229
Figure 144
IP Source Guard > ARP Inspection VLAN Status
The following table describes the labels in this screen.
24.6.2 ARP Inspection Log Status
Use this screen to look at log messages that were generated by ARP packets and that have not
been sent to the syslog server yet. To open this screen, click Advanced Application > IP Source
Guard > ARP Inspection > Log Status.
Table 113
IP Source Guard > ARP Inspection VLAN Status
LABEL
DESCRIPTION
Show VLAN range
Use this section to specify the VLANs you want to look at in the section below.
Enabled VLAN
Select this to look at all the VLANs on which ARP inspection is enabled in the section
below.
Selected VLAN
Select this to look at all the VLANs in a specific range in the section below. Then, enter
the lowest VLAN ID (Start VID) and the highest VLAN ID (End VID) you want to look
at.
Apply
Click this to display the specified range of VLANs in the section below.
VID
This field displays the VLAN ID of each VLAN in the range specified above.
Received
This field displays the total number of ARP packets received from the VLAN since the
Switch last restarted.
Request
This field displays the total number of ARP Request packets received from the VLAN
since the Switch last restarted.
Reply
This field displays the total number of ARP Reply packets received from the VLAN since
the Switch last restarted.
Forwarded
This field displays the total number of ARP packets the Switch forwarded for the VLAN
since the Switch last restarted.
Dropped
This field displays the total number of ARP packets the Switch discarded for the VLAN
since the Switch last restarted.