Chapter 22 Multicast
GS3700/XGS3700 Series User’s Guide
185
Figure 114
Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping > IGMP Filtering
Profile
The following table describes the labels in this screen.
Table 87
Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping > IGMP Filtering
Profile
LABEL
DESCRIPTION
Profile Name
Enter a descriptive name for the profile for identification purposes.
To configure additional rule(s) for a profile that you have already added, enter the profile
name and specify a different IP multicast address range.
Start Address
Type the starting multicast IP address for a range of multicast IP addresses that you want
to belong to the IGMP filter profile.
End Address
Type the ending multicast IP address for a range of IP addresses that you want to belong
to the IGMP filter profile.
If you want to add a single multicast IP address, enter it in both the Start Address and
End Address fields.
Add
Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Clear
Click Clear to reset the fields to the factory defaults.
Profile Name
This field displays the descriptive name of the profile.
Start Address
This field displays the start of the multicast address range.
End Address
This field displays the end of the multicast address range.
Delete
To delete the profile(s) and all the accompanying rules, select the profile(s) that you want
to remove in the Delete Profile column, then click the Delete button.
To delete a rule(s) from a profile, select the rule(s) that you want to remove in the Delete
Rule column, then click the Delete button.
Cancel
Click Cancel to clear the Delete Profile/Delete Rule check boxes.