Chapter 42 Maintenance
GS3700/XGS3700 Series User’s Guide
345
42.2 Load Factory Default
Follow the steps below to reset the Switch back to the factory defaults.
1
In the Maintenance screen, click the Click Here button next to Load Factory Default to clear all
Switch configuration information you configured and return to the factory defaults.
2
Click OK to reset all Switch configurations to the factory defaults.
Figure 239
Load Factory Default: Start
3
In the web configurator, click the Save button in the top of the screen to make the changes take
effect. If you want to access the Switch web configurator again, you may need to change the IP
address of your computer to be in the same subnet as that of the default Switch IP address
(192.168.1.1).
42.3 Save Configuration
Click Config 1 to save the current configuration settings permanently to configuration one on the
Switch.
Click Config 2 to save the current configuration settings to configuration two on the Switch.
Alternatively, click Save on the top right-hand corner in any screen to save the configuration
changes to the current configuration.
Note: Clicking the Apply or Add button does NOT save the changes permanently. All
unsaved changes are erased after you reboot the Switch.
Reboot
System
Click Config 1 to reboot the system and load Configuration 1 on the Switch.
Click Config 2 to reboot the system and load Configuration 2 on the Switch.
Note: Make sure to click the
Save
button in any screen to save your settings to the current
configuration on the Switch.
Tech-Support
Click Click Here to see the Tech-Support screen. You can set CPU and memory thresholds
for log reports and download related log reports for issue analysis. Log reports include CPU
history and utilization, crash and memory.
Table 182
Management > Maintenance (continued)
LABEL
DESCRIPTION