Chapter 23 AAA
GS3700/XGS3700 Series User’s Guide
203
23.2.2 TACACS+ Server Setup
Use this screen to configure your TACACS+ server settings. See
more information on TACACS+ servers. Click on the TACACS+ Server Setup link in the
Authentication and Accounting screen to view the screen as shown.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Accounting
Server
Use this section to configure your RADIUS accounting server settings.
Timeout
Specify the amount of time in seconds that the Switch waits for an accounting request
response from the RADIUS accounting server.
Index
This is a read-only number representing a RADIUS accounting server entry.
IP Address
Enter the IP address of an external RADIUS accounting server in dotted decimal notation.
UDP Port
The default port of a RADIUS accounting server for accounting is 1813. You need not
change this value unless your network administrator instructs you to do so.
Shared Secret
Specify a password (up to 32 alphanumeric characters) as the key to be shared between
the external RADIUS accounting server and the Switch. This key is not sent over the
network. This key must be the same on the external RADIUS accounting server and the
Switch.
Delete
Check this box if you want to remove an existing RADIUS accounting server entry from the
Switch. This entry is deleted when you click Apply.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Table 97
Advanced Application > AAA > RADIUS Server Setup (continued)
LABEL
DESCRIPTION