Chapter 34 Link Layer Discovery Protocol (LLDP)
GS3700/XGS3700 Series User’s Guide
288
Figure 186
Advanced Application > LLDP > LLDP Configuration
The following table describes the labels in this screen.
Table 149
Advanced Application > LLDP > LLDP Configuration
LABEL
DESCRIPTION
Active
Select to enable LLDP on the Switch. It is enabled by default.
Transmit Interval
Enter how many seconds the Switch waits before sending LLDP packets.
Transmit Hold
Enter the time-to-live (TTL) multiplier of LLDP frames. The device information on the
neighboring devices ages out and is discarded when its corresponding TTL expires. The
TTL value is to multiply the TTL multiplier by the LLDP packets transmitting interval.
Transmit Delay
Enter the delay (in seconds) between successive LLDPDU transmissions initiated by value
or status changes in the Switch MIB.
Reinitialize Delay
Enter the number of seconds for LLDP to wait before initializing on a port.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Port
This displays the port number with this LLDP configuration. * means all ports.