47 

Type 

(Assignable Buttons only)

The Type determines how the Assignable Buttons function when pressed. Additional settings 
are associated with each Type. 

To change a button's type: 

1.

Enter Control Mode by pressing the 

Control Mode Button (Ctrl)

. 

2.

Press the second 

Function Button (Edit Controls)

. The display will tell you to move the 

desired control. 

3.

Press the 

Control Bank

 button to select the desired bank. 

Move the 

Assignable Control

 you want to edit (press a button), or use the 

Value Dial

 to 

select it. The control type and number will appear in the upper right corner of the display. 
When you have selected the desired control, press the third 

Function Button (Edit 

Control)

. 

4.

Press the second 

Function Button (Type)

 to cycle through the available options:  

•

Momentary:

 The button will be on for as long as you are holding the button down. 

When you release it, it will turn off. Use the third 

Assignable Knob (Press)

 and 

fourth 

Assignable Knob (Release)

 to set the values that the control will send (

00

–

127

) when pressed and released. 

•

Toggle:

 Each time you press the button, it will turn on or off and remain in that state 

until you press it again. Use the third 

Assignable Knob (On)

 and fourth 

Assignable 

Knob (Off)

 to set the values that the control will send (

00

–

127

) when turned on and 

off.  

•

Single:

 Each time you press the button, it will send its CC value once. Use the third 

Assignable Knob (Value)

 to set the value that the control will send (

00

–

127

) when 

pressed. 

Tip:

 See the 

Colors

 section on the previous page to learn how to set the "on" and "off" 

colors for the buttons. 

5.

Make other changes in Control Mode, or exit Control Mode by pressing the 

Control

Mode Button (Ctrl)

 or the fourth 

Function Button (Exit)

 three times. 

