![background image](/i/m-audio/157048/m-audio-trigger-finger-pro/h/m-audio-trigger-finger-pro-049.png)
49
MIDI Channel and Output
The MIDI settings determine over which MIDI channel each control sends its messages and
whether the messages are sent over Trigger Finger Pro's USB Port, MIDI Out jack, or both.
To change a control's MIDI channel and output configuration:
1.
Enter Control Mode by pressing the
Control Mode Button (Ctrl)
.
2.
Press the second
Function Button (Edit Controls)
. The display will tell you to move the
desired control.
3.
Press the
Control Bank
button to select the desired bank.
Move the
Assignable Control
you want to edit (move a fader or knob, or press a button),
or use the
Value Dial
to select it. The control type and number will appear in the upper
right corner of the display. When you have selected the desired control, press the third
Function Button (Edit Control)
.
4.
Press the third
Function Button (More)
.
5.
Turn the fourth
Assignable Knob (MIDI-Ch)
to set the MIDI channel over which the
control will send its messages (
01
–
16
or
UsePrefs
).
Press the first
Function Button (Output)
to cycle through the available MIDI output
configurations the control can send its messages (
USB+Jack
,
USB
,
Jack
, or
UsePrefs
).
(
Jack
refers to Trigger Finger Pro's
MIDI Out
jack.)
For either setting, when
UsePrefs
is selected, the control will use whatever settings are in
Trigger Finger Pro's
Preferences
. See the
chapter to learn more
about this.
6.
Make other changes in Control Mode, or exit Control Mode by pressing the
Control
Mode Button (Ctrl)
or the fourth
Function Button (Exit)
three times.