65
Velocities
Each pad used in a Sequence can play its notes at independent velocities for each step, which you
can edit.
To edit step velocities:
1.
Enter Sequence Mode by pressing the
Sequence Mode (Seq)
button.
2.
Check above the third
Function Button (Page)
to make sure you are viewing
Page 1
. If you are
on Page 2, press the button to move to Page 1.
3.
Press the second
Function Button (Edit Velocity)
. The steps of the Sequence will be shown in
the display with the steps' numbers in the first (top) row and their corresponding velocity values
below them in the second row.
4.
Before editing any values, make sure you have selected the desired bar and pad of the
Sequence:
Select the desired pad either by simply pressing it (in the desired pad bank) or by turning the
first and/or second
Assignable Knobs (Bank
and
Pad)
.
Select the desired bar either by turning the third
Assignable Knob (Bar)
or pressing and
holding
Select
and then pressing one of
Step Indicators 1-5
.
5.
Turn the
Value Dial
to select a step, and then press the
Value Dial
to select its velocity. (The
currently selected step number or velocity value will flash.)
6.
Turn the
Value Dial
to adjust the velocity value (
00
–
127
).
If you want to tie the step to the previous one (creating a "held" note), press the first
Function
Button (Tie)
to activate or deactivate the tie function. Alternatively, press and hold a
Step
Switch
for two seconds. When a step is tied, the step before it will determine the velocity, and
its
Step Switch
will be partially lit. You can tie multiple steps in a row.
To erase all steps for that pad, press the second
Function Button (Clr Pad)
.
Be careful—this
cannot be undone!
To erase all steps
for all pads
in the Sequence, press the third
Function Button (Clr All)
.
Be
careful—this cannot be undone!
7.
To select a different step, press the
Value Dial
and then repeat Steps 4-6.
8.
Make other changes, or exit Sequence Mode by pressing the
Sequence Mode (Seq)
button or
fourth
Function Button (Exit)
twice.
