Chapter 14 Mirroring
GS3700/XGS3700 Series User’s Guide
134
14.1.4 Destination
Use this screen to specify the RMirror VLAN and configure the monitor port when the Switch is the
destination device in remote port mirroring.
Click the Destination link in the RMirror screen. The following screen opens.
Figure 83
Advanced Application > Mirroring > RMirror > Destination
The following table describes the labels in this screen.
Direction
Specify the direction of the traffic to mirror by selecting from the drop-down list box.
Choices are Egress (outgoing), Ingress (incoming) and Both.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the nonvolatile memory when you are done
configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
VLAN
This field displays the ID number of RMirror VLAN over which the mirrored traffic is
forwarded.
Priority
This field displays the priority of the mirrored traffic.
Mirror Port
Ingress
This field displays the number of port(s) on which the incoming traffic is mirrored.
Egress
This field displays the number of port(s) on which the outgoing traffic is mirrored.
Both
This field displays the number of port(s) on which the incoming and outgoing traffic is
mirrored.
Reflector Port
This field displays whether the reflector port is enabled and the number of reflector
port in this RMirror VLAN.
Table 57
Advanced Application > Mirroring > RMirror > Source (continued)
LABEL
DESCRIPTION
Table 58
Advanced Application > Mirroring > RMirror > Destination
LABEL
DESCRIPTION
RMirror VLAN ID
Select the RMirror VLAN over which the mirrored traffic is forwarded.
Monitor Port
Specify the port to which you copy the traffic in order to examine it in more detail
without interfering with the traffic flow on the original port(s).