Инструкция для ZYXEL GS3700-48

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Chapter 17 Port Security

GS3700/XGS3700 Series User’s Guide

154

The following table describes the labels in this screen.

17.3 VLAN MAC Address Limit

Use this screen to set the MAC address learning limit on per-port and per-VLAN basis. Click VLAN
MAC Address Limit in the Advanced Application > Port Security screen to display the screen
as shown.

Table 68

Advanced Application > Port Security

LABEL

DESCRIPTION

Port List

Enter the number of the port(s) (separated by a comma) on which you want to enable port
security and disable MAC address learning. After you click MAC freeze, all previously
learned MAC addresses on the specified port(s) will become static MAC addresses and
display in the Static MAC Forwarding screen.

MAC freeze

Click MAC freeze to have the Switch automatically select the Active check boxes and
clear the Address Learning check boxes only for the ports specified in the Port list.

Active

Select this option to enable port security on the Switch.

Port

This field displays a port number.

Settings in this row apply to all ports.

Use this row only if you want to make some of the settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port basis.

Note: Changes in this row are copied to all the ports as soon as you make them.

Active

Select this check box to enable the port security feature on this port. The Switch forwards
packets whose MAC address(es) is in the MAC address table on this port. Packets with no
matching MAC address(es) are dropped.

Clear this check box to disable the port security feature. The Switch forwards all packets
on this port.

Address Learning MAC address learning reduces outgoing broadcast traffic. For MAC address learning to

occur on a port, the port itself must be active with address learning enabled.

Limited Number
of Learned MAC
Address

Use this field to limit the number of (dynamic) MAC addresses that may be learned on a
port. For example, if you set this field to "5" on port 2, then only the devices with these
five learned MAC addresses may access port 2 at any one time. A sixth device must wait
until one of the five learned MAC addresses ages out. MAC address aging out time can be
set in the Switch Setup screen. The valid range is from “0” to “16K”. “0” means this
feature is disabled.

Apply

Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.

Cancel

Click Cancel to begin configuring this screen afresh.