Chapter 22 Multicast
GS3700/XGS3700 Series User’s Guide
190
22.4.4 MLD Snooping-proxy Filtering
Use this screen to configure the Switch’s MLD filtering settings. Click the MLD Snooping-proxy
link and then the Filtering link in the Advanced Application > Multicast > IPv6 Multicast
screen to display the screen as shown. See
multicasting.
Figure 119
Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
Leave Timeout
Enter the MLD snooping normal leave timeout (in milliseconds) the Switch uses to update
the forwarding table for the specified downstream port(s).
This defines how many seconds the Switch waits for an MLD report before removing an
MLD snooping membership entry (learned on a downstream port) when an MLD Done
message is received on this port from a host.
Fast Leave
Timeout
Enter the fast leave timeout (in milliseconds) for the specified downstream port(s).
This defines how many seconds the Switch waits for an MLD report before removing an
MLD snooping membership entry (learned on a downstream port) when an MLD Done
message is received on this port from a host.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to reset the fields to your previous configuration.
Table 91
Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > VLAN > Port
Role Setting (continued)
LABEL
DESCRIPTION