Инструкция для ZYXEL GS3700-48

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Chapter 46 Cluster Management

GS3700/XGS3700 Series User’s Guide

383

The following table describes the labels in this screen.

Table 207

Management > Clustering Management > Configuration

LABEL

DESCRIPTION

Clustering Manager

Active

Select Active to have this Switch become the cluster manager switch. A cluster can
only have one manager. Other (directly connected) switches that are set to be cluster
managers will not be visible in the Clustering Candidates list. If a switch that was
previously a cluster member is later set to become a cluster manager, then its Status is
displayed as Error in the Cluster Management Status screen appears in the member
summary list below.

Name

Type a name to identify the Clustering Manager. You may use up to 32 printable
characters (spaces are allowed).

VID

This is the VLAN ID and is only applicable if the Switch is set to 802.1Q VLAN. All
switches must be directly connected and in the same VLAN group to belong to the same
cluster. Switches that are not in the same VLAN group are not visible in the Clustering
Candidates list. This field is ignored if the Clustering Manager is using Port-based
VLAN.

Apply

Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.

Cancel

Click Cancel to begin configuring this screen afresh.

Clustering
Candidate

The following fields relate to the switches that are potential cluster members.

List

A list of suitable candidates found by auto-discovery is shown here. The switches must
be directly connected. Directly connected switches that are set to be cluster managers
will not be visible in the Clustering Candidate list. Switches that are not in the same
management VLAN group will not be visible in the Clustering Candidate list.

Password

Each cluster member’s password is its web configurator password. Select a member in
the Clustering Candidate list and then enter its web configurator password. If that
switch administrator changes the web configurator password afterwards, then it cannot
be managed from the Cluster Manager. Its Status is displayed as Error in the Cluster
Management Status screen.

If multiple devices have the same password then hold [SHIFT] and click those switches
to select them. Then enter their common web configurator password.

Add

Click Add to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.

Cancel

Click Cancel to begin configuring this screen afresh.

Refresh

Click Refresh to perform auto-discovery again to list potential cluster members.

The next summary table shows the information for the clustering members configured.

Index

This is the index number of a cluster member switch.

MacAddr

This is the cluster member switch’s hardware MAC address.

Name

This is the cluster member switch’s System Name.

Model