![background image](/i/zyxel/143450/zyxel-gs3700-48/h/zyxel-gs3700-48-048.png)
Chapter 5 ZON Utility, ZON Neighbor Management and Port Status
GS3700/XGS3700 Series User’s Guide
48
Figure 20
Status
The following table describes the labels in this screen.
Table 7
Status
LABEL
DESCRIPTION
Port
This identifies the Ethernet port. Click a port number to display the Port Details screen
(refer to
).
Name
This is the name you assigned to this port in the Basic Setting > Port Setup screen.
Link
This field displays the speed (such as 100M for 100 Mbps, 1000M for 1000 Mbps, or 10G
for 10 Gbps) and the duplex (F for full duplex). This field displays Down if the port is not
connected to any device.
State
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port. (See
for more information).
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it displays
STOP.
PD
(For PoE models only) This field displays whether or not a powered device (PD) is allowed to
receive power from the Switch on this port.
LACP
This fields displays whether LACP (Link Aggregation Control Protocol) has been enabled on
the port.
TxPkts
This field shows the number of transmitted frames on this port.
RxPkts
This field shows the number of received frames on this port.
Errors
This field shows the number of received errors on this port.
Tx KB/s
This field shows the transmission speed of data sent on this port in kilobytes per second.
Rx KB/s
This field shows the transmission speed of data received on this port in kilobytes per second.
Up Time
This field shows the total amount of time in hours, minutes and seconds the port has been
up.
Clear Counter
Type a port number, select Port and then click Clear Counter to erase the recorded
statistical information for that port, or select Any to clear statistics for all ports.