Chapter 5 ZON Utility, ZON Neighbor Management and Port Status
GS3700/XGS3700 Series User’s Guide
47
The following table describes the fields in the above screen.
5.4 Port Status Summary
To view the port statistics, click Status in all web configurator screens to display the Status screen
as shown next.
Table 6
Status > Neighbor
LABEL
DESCRIPTION
Local
Port
This shows the port number of the local device in the network.
Name
This shows the name of the local device in the network.
PoE Draw
This shows the consumption that the local device in the network draws from the
Switch. This allows you to plan and use within the power budget of the Switch.
Remote
Model Name
This shows the model name of the neighbor device in the remote network. This field
will show “-” for non-ZyXEL devices.
Sys. Name
This shows the system name of the neighbor device in the remote network.
FW Version
This shows the firmware version of the neighbor device in the remote network. This
field will show “-” for non-ZyXEL devices.
Port
This show the port number of the neighbor device in the remote network.
Port Description
This shows the port description of the neighbor device in the remote network.
IP
This shows the IP address of the neighbor device in the remote network. The IP
address is a hyper link that you can click and login the remote device. This field will
show “-” for non-ZyXEL devices.
MAC
This shows the MAC address of the neighbor device in the remote network. This field
will show “-” for non-ZyXEL devices.
PWR Cycle
Click the Cycle button to turn OFF the power of the neighbor device in the remote
network and turn it back ON again. A count down button (from 5 to 0) starts.
Note: The Switch must support power sourcing (PSE) or the network device is a
powered device (PD).
Note: If multiple neighbor devices use the same port, the
Cycle
button is displayed only
on the first device, others will show “
-
” instead.
Reset to Default
Click the Reset button to reset the neighbor device in the remote network to its
factory default settings. A warning message “Are you sure you want to load
factory default?” appears prompting you to confirm the action. After confirming the
action a count down button (from 5 to 0) starts.
Note: The Switch must support power sourcing (PSE) or the network device is a
powered device (PD).
Note: If multiple neighbor devices use the same port, the
Reset
button is not available
and will show “
-
” instead.
Note: You can only reset ZyXEL products.