Инструкция для ZYXEL GS3700-48

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Chapter 22 Multicast

GS3700/XGS3700 Series User’s Guide

196

22.6.1 MVR Group Configuration

All source ports and receiver ports belonging to a multicast group can receive multicast data sent to
this multicast group.

Use this screen to configure MVR IP multicast group address(es). Click the Group Configuration
link in the MVR screen.

Note: A port can belong to more than one multicast VLAN. However, IP multicast group

addresses in different multicast VLANs cannot overlap.

Settings in this row apply to all ports.

Use this row only if you want to make some settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.

Note: Changes in this row are copied to all the ports as soon as you make them.

Source Port

Select this option to set this port as the MVR source port that sends and receives multicast
traffic. All source ports must belong to a single multicast VLAN.

Receiver Port

Select this option to set this port as a receiver port that only receives multicast traffic.

None

Select this option to set the port not to participate in MVR. No MVR multicast traffic is sent
or received on this port.

Tagging

Select this checkbox if you want the port to tag the VLAN ID in all outgoing frames
transmitted.

Add

Click this to create a new entry or to update an existing one.

This saves your changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.

Cancel

Click Cancel to begin configuring this screen afresh.

VLAN

This field displays the multicast VLAN ID. Click on an index number to change the settings.

Active

This field displays whether the multicast group is enabled or not.

Name

This field displays the descriptive name for this setting.

Mode

This field displays the MVR mode.

Source Port

This field displays the source port number(s).