Инструкция для ZYXEL GS3700-48

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Chapter 4 The Web Configurator

GS3700/XGS3700 Series User’s Guide

PPPoE

This link takes you to screens where you can configure how the Switch gives a PPPoE
termination server additional subscriber information that the server can use to identify
and authenticate a PPPoE client.

Errdisable

This link takes you to a screen where you can configure CPU protection and error disable
recovery.

MAC Pinning

This link takes you to a screen where you can set specific ports to have priority over other
ports in MAC address learning.

Private VLAN

This link takes you to a screen where you can block traffic between ports in a VLAN on the
Switch.

Green Ethernet

This link takes you to a screen where you can configure the Switch to reduce port power
consumption.

LLDP

This link takes you to a screen where you can configure LLDP settings.

IP Application

Static Routing

This link takes you to a screen where you can configure static routes. A static route
defines how the Switch should forward traffic by configuring the TCP/IP parameters
manually.

Policy Routing

This link takes you to screens where you can configure policy routing rules.

DiffServ

This link takes you to screens where you can enable DiffServ, configure marking rules and
set DSCP-to-IEEE802.1p mappings.

DHCP

This link takes you to screens where you can configure the DHCP settings.

VRRP

This link takes you to screens where you can configure redundant virtual router for your
network.

Load Sharing

This link takes you to a screen where you can enable Equal-Cost MultiPath (ECMP) routing
and set the criteria the Switch uses to determine the routing path for a packet.

ARP Setup

This link takes you to a screen where you can configure ARP learning mode on a per-port
basis and create static ARP entries which do not age out.

Management

Maintenance

This link takes you to screens where you can perform firmware and configuration file
maintenance as well as reboot the system.

Access Control

This link takes you to screens where you can change the system login password and
configure SNMP and remote management.

Diagnostic

This link takes you to screens where you can view system logs and can test port(s).

Syslog

This link takes you to screens where you can setup system logs and a system log server.

Cluster
Management

This link takes you to a screen where you can configure clustering management and view
its status.

MAC Table

This link takes you to a screen where you can view the MAC address and VLAN ID of a
device attach to a port. You can also view what kind of MAC address it is.

IP Table

This link takes you to a screen where you can view the IP addresses and VLAN ID of a
device attached to a port.You can also view what kind of device it is.

ARP Table

This link takes you to a screen where you can view the MAC address – IP address
resolution table.

Routing Table

This link takes you to a screen where you can view the routing table.

Path MTU Table

This link takes you to a screen where you can view the IPv6 path MTU table.

Configure Clone

This link takes you to a screen where you can copy attributes of one port to (an)other
port(s).

Neighbor Table

This link takes you to a screen where you can view the Switch’s IPv6 neighbor table.

Table 5

Navigation Panel Links (continued)