Chapter 43 Access Control
GS3700/XGS3700 Series User’s Guide
371
Figure 262
Management > Access Control > Service Access Control
The following table describes the fields in this screen.
43.11 Remote Management
From the Access Control screen, display the Remote Management screen as shown next.
You can specify a group of one or more “trusted computers” from which an administrator may use a
service to manage the Switch. Click Access Control to return to the Access Control screen.
Table 198
Management > Access Control > Service Access Control
LABEL
DESCRIPTION
Services
Services you may use to access the Switch are listed here.
Active
Select this option for the corresponding services that you want to allow to access the Switch.
Service Port
For Telnet, SSH, FTP, HTTP or HTTPS services, you may change the default service port by
typing the new port number in the Service Port field. If you change the default port number
then you will have to let people (who wish to use the service) know the new port number for
that service.
Timeout
Type how many minutes (from 1 to 255) a management session can be left idle before the
session times out. After it times out you have to log in with your password again. Very long
idle timeouts may have security risks.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.