Chapter 6 Basic Setting
GS3700/XGS3700 Series User’s Guide
66
Note: If the priority settings for two or more PoE ports are the same and the power
budget is not enough, the ports will shut down randomly. We strongly recommend
you set the priority for each PoE port to make sure the high priority ports get
power.
Note: In classification mode, up to five ports can be active. (The Switch reserves 36W per
port and the total power budget is 180W). Select consumption mode if you want
more ports to be active.
6.8 Interface Setup
An IPv6 address is configured on a per-interface basis. The interface can be a physical interface (for
example, an Ethernet port) or a virtual interface (for example, a VLAN). The Switch supports the
VLAN interface type for IPv6 at the time of writing.
Use this screen to set IPv6 interfaces on which you can configure an IPv6 address to access and
manage the Switch. Click Basic Setting > Interface Setup in the navigation panel to display the
configuration screen.
Figure 31
Basic Setting > Interface Setup
Max Power (mW)
Set the maximum amount of power (from 1000 to 33000) the PD could use from the
Switch on this port. Otherwise, leave the field blank to allow the connected PD to use
power up to the Switch’s total power budget.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the nonvolatile memory when you are done
configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Table 15
Basic Setting > PoE Status > PoE Setup
LABEL
DESCRIPTION