![background image](/i/loewe/153202/loewe-reference-ld-46-reference-id-40-reference-ld-55/h/loewe-reference-ld-46-reference-id-40-reference-ld-55-006.png)
Reference ID 40-55
- 6 -
User guide
For your safety, and to avoid unnecessary damage to your unit,
please read and follow the safety advice below:
Use for the intended purpose and ambient conditions
This TV set is intended exclusively for rendering video and audio signals
and is designed for use in residential apartments or office premises.
It must not be used in rooms with a high level of
humidity
(e.g., bath-
room, sauna) or a high
dust concentration
(e.g., workshops). The
manufacturer‘s warranty is only valid for use in the specified permis-
sible environment.
If the unit is used outdoors, make sure that it is protected from
moisture
(rain, dripping water and splashing water or dew). High humidity and
dust concentrations lead to leakage currents in the device. This can
result in a shock hazard by touching it or even fire.
If you have moved the unit out of
the
cold
into a warm environment,
leave it switched off for about an
hour to avoid the formation of
condensation
.
Do not place
objects
containing
liquids
on top of the unit. Protect
the appliance against dripping and
splashing water.
Candles
or
naked flames
must be
kept away from the TV set at all
times to prevent it from catching
fire.
Never place the TV set in a location
where it is exposed to
vibrations
.
This can lead to material overload.
Transporting
Move the device in
vertical position
only. Grasp the device on the
upper and lower edges of the housing.
The set is delivered ex factory without a mounting option. If the set
has to be put down during packing/unpacking, place the TV set with
its entire front surface lying flat on soft material such as a blanket or
the fleece from the packing material. Use a blanket or the fleece from
the packing material as an underlay.
The LCD screen is made of glass or plastic and can break if not handled
properly.
Always wear rubber gloves to carry the TV set if the LCD screen is
damaged and
liquid
crystal might be leaking out. In the case of
skin
contact
immediately rinse thoroughly with water.
Power supply
Incorrect voltages
can damage the unit. This device may only be con-
nected to a power supply with the voltage and frequency indicated on the
type plate using the supplied mains cable. The
mains plug
of the TV set
must be easily accessible so that the device can be disconnected from
the mains at any time. When unplugging the unit from the mains, pull at
the connector body and not at the
cable
. The cables in the mains plug
could otherwise be damaged and could cause a
short-circuit
when
plugged in again.
Lay the
mains cable
so that it can not be damaged. The power cable
may not be kinked or laid over sharp edges, stood on or exposed to
chemicals
; the latter also applies to the unit as a whole. A power
cable with damaged insulation can cause
electric shocks
and poses
a
fire risk
.
Air circulation and high temperatures
The
vent slots
on the
rear panel of the set
must always be kept un-
obstructed. Please do not place newspapers or cloths on/over the TV
set.
Ensure that there is at least
10 cm free space on the sides
and above the set for air cir-
culation, if the set is placed in
a
cabinet
or on a
shelf
.
Like any electronic device,
your TV set requires
air for
cooling
. Obstruction of the
air circulation can cause fires.
Prevent
metal items
, nee-
dles, paper clips, liquids, wax,
or similar items, from getting
into the interior of the device through the
vent slots
in the rear panel.
Such objects can cause
short circuits
in the set, which could pos-
sibly cause a fire.
If something should get into the
interior of the set
then immedi-
ately unplug the mains plug of the device and contact the
field service
for more information.
Set-up
The set is suitable for mounting in many different ways. Note the as-
sembly instructions regarding the different possible mounting options.
Before setting up the device, please check that the final location is
suitable to bear the load of the device in terms of surface (sensitivity
to pressure) and stability.
Place the TV set with the stand only on a
level, sturdy, horizontal
base
. Particularly ensure that the set does not protrude to the front
when placed in or on pieces of furniture.
Place the TV set in a normal position for use. TV set may only be used
in an upright
horizontal
position. It may not be tilted by more than 10
degrees. The TV set must never be operated vertically, lying flat or
hanging overhead from the ceiling.
Set up the device where it is not exposed to direct
insolation
and
where it is not exposed to additional heating by
radiators
.
Note on the LCD screen
The TV set with LCD screen you have purchased satisfies the most
rigorous quality requirements and has been inspected with respect
to
pixel errors
. Despite of thorough care when manufacturing the
display, it cannot be 100% guaranteed that no
subpixel
defects will
occur due to technical reasons. Please understand that these types
of effects, as long as they are within the standard of specified limits,
cannot be considered as a device defect in terms of the guarantee.
Avoid displaying still images for long periods of time. It is possible that
a copy of the image may remain.
10 cm
10 cm
10 cm
±10°
n
For your safety