Printer Overview
1-9
OG
L
0 0
Powering On the Printer
The location of the main power switch is shown below. The switch is marked “O” for
Off and “I” for On.
When the printer is powered on, the printer and the finisher go through a power-up
sequence that takes approximately 4 minutes. During the power-up sequence, the
printer runs a series of internal tests.
CAUTION
!
If the printer does not power on, power off the printer, wait at least 30
seconds, then power n the printer again.
NOTE
:
The entire system should be powered On and Off using the main power
switch shown above. To do this, both the front and rear engine power
switches must remain in the On position. If either the front or rear engine
power switch is in the Off position, an error will occur or the OCP display
will not come up. In this situation, turn Off the main power switch, turn
On the power to the front and/or rear engine, then turn On the main power
switch.
Main Power Switch