3-30
Paper Handling
OG
L
0 0
Back Side/Back Engine
Compare the lines printed by the front and rear engine. If the lines printed by the rear
engine do not align with the lines printed by the front engine, perform the following
steps.
1.
For Vertical line adjustment make the following selections from the OCP:
Printer / Paper Source / Color Control / Tray # / V Direction / Duplex / R: Back
Side
2.
Select the desired value and press enter (
).
3.
For Horizontal line adjustment make the following selections from the OCP:
Printer / Paper Source / Color Control / Tray # / H Direction / Duplex / R: Back
Side
4.
Select the desired value and press enter (
).
5.
Print another Cross Pattern to verify the adjustment. If further adjustment is
necessary repeat Steps 1 through 4 until alignment is achieved.