Paper Handling
3-9
OG
L
0 0
5.
Place the paper into the tray.
6.
Adjust the size guide until the gap is less than 1mm, then tighten the Thumb
Screw. (Skip to Step 7 if the Thumb Screw is not installed).
7.
Close the tray.
8.
If you set the sensor plate to
in
Step
3
, select the paper size from the OCP by
making the following selections:
Printer/Paper Source/Paper Size/Tray Number/Paper Size
9.
Adjust the paper weight. The default paper weight is 20 lb. bond. If necessary,
change the paper weight by making the following selections:
Printer/Paper Source/
/Paper Weight/tray number
10.
Select Index, Bond, or g/m
2
, then use the keypad to input the weight and press
.
NOTE
:
The paper should be loaded no higher than the Max. level indicator. The
Max. level indicator is located inside the tray.