Operator Control Panel 2-17
OG
L
0 0
Setup Menu
When you select Setup from the Main Menu, this screen is displayed. Use it to gain
access to the Setup option screens that are described below. See
Table 2-4 on page 2-
20
for the complete Setup Menu structure.
OCP
Touch to display the OCP screen. You use this screen to adjust the brightness and
contrast values for the OCP display. The range is 1 to 16. The factory default is 10.
Service
The Service option is password protected. Contact your Authorized Service Technician
for more information.
System
The System option is password protected. Contact your System Administrator if you
need access to these options.
Software
Front Engine
Create software log
Rear Engine
Create software log
Network
Front Engine
IP Address - Factory default is 10.0.1.1 (Do not change)
Subnet Mask - Factory default is 0.0.0.0.
Gateway Address - Factory default is 0.0.0.0
Boot Method - Factory default is STATIC
HTTP Port - Factory default is 80
Rear Engine
IP Address - Factory default is 10.0.2.1 (Do not change)
Subnet Mask - Factory default is 0.0.0.0.
Gateway Address - Factory default is 0.0.0.0
Boot Method - Factory default is STATIC
HTTP Port - Factory default is 80
CAUTION
!
If you change the Network parameters, the DDP Server will not be able to
communicate with the printers.