Operator Control Panel 2-13
OG
L
0 0
Default Output
This option button is not available.
Options
Exit Jam Recovery
Can be set to enable or disable. When set to enable, the printer will reprint pages
that were improperly printed due to a paper jam.
Wait Timeout
Defines the waiting period (in seconds) from reception of last data to the
reception of next data. If data is not received within the defined period, the job is
cancelled. The valid range is 0 - 999 seconds. The factory default is 40 seconds. A
command from the host will override the OCP setting.
LPD Queuing
This option is not normally used in the 184 printing environment. The factory
default is disabled.
Duplex Always
Can be set to enable or disable
Print Density
Print Density can be adjusted to five settings: Light, Semi-Light, Middle, Semi-
Dark or Dark
Detach Voltage
It is recommended that you contact your authorized Service Technician prior to
making any change to the detach voltage settings.
Heat Roll TMP
Heat Roll Temperature can be adjusted to three settings:
(Low: 180 C, Normal: 190 C, High: 200 C)
Laser Power
This option can be adjust to 31 levels from -15 to +15. The laser line becomes
thinner at the - settings and wider at the + settings.
DBL Feed Detect
Can be set to enable or disable.
H Positioning
Can be set to enable or disable. When set to enable, skew detect can be set to
enable or disable.
PostScript
PostScript options are not available.
Test Print
Use this option button to select from the various test print patterns.