3-28
Paper Handling
OG
L
0 0
Finisher Adjustment
See Appendix D
for instructions on adjusting the Finisher stapling and folding position
Setting the Color Control
Due to shrinkage that can occur during the fusing process, the image size may need to
be adjusted between the front and rear printer. Follow the instructions below to adjust
image size. For additional information refer to
page 2-12
.
Cross Pattern
1.
Make the following selections from the OCP:
Printer / Paper Source / Color Control / Tray Number / H Direction / Duplex /
Cross Pattern
2.
When the ten-key screen is displayed, enter “1” and press enter (
). The printer
will print a Cross Pattern page as shown below.
『
Simplex
Path
』
『
Lead Edge
』
Lead Edge
Simplex Path
V Direction (paper width direction)
Lines printed by
the front engine
Lines printed by
the rear engine.
H Direction (paper length direction)
Simplex Path
Leading Edge
Front Side
Simplex Path
『
Simplex
Path
』
『
Lead Edge
』
Lead Edge
Simplex Path
V Direction (paper width direction)
H Direction (paper length direction)
Duplex Path
Leading Edge
Back Side
Check 1
Check 2
Duplex Path