21 (E)

4.  Set the left-most limit position in the travel range.
    Operate the PAN/TILT lever on the control panel to 

rotate the camera to the position which is to serve as 
the left-most limit position.

   While holding down the OK button, press button 44 .
    The setting is completed when the 41 [LIMIT ON] 

button’s lamp comes on.

     To cancel the setting, press button 44  while pressing 

the OK button again. When the setting is cancelled, 
the 50 [LIMIT OFF] button’s lamp comes on.

5.  Set the right-most limit position in the travel range.
    Operate the PAN/TILT lever on the control panel to 

rotate the camera to the position which is to serve as 
the right-most limit position.

   While holding down the OK button, press button 45 .
    The setting is completed when the 41 [LIMIT ON] 

button’s lamp comes on.

     To cancel the setting, press button 45  while pressing 

the OK button again. When the setting is cancelled, the 
50 [LIMIT OFF] button’s lamp comes on.

6.   Select the next pan/tilt head system using the 

CONTROL/PREVIEW MONITOR OUT SEL button, 
and continue setting the travel range (limiters) for each 
system concerned.

Genlock adjustment

If a camera is to be synchronized with an external signal for 
use, genlock adjustment must be performed for the camera 
and other equipments.
Either the black burst or VBS (video, burst and sync) signal 
is used for the external sync signal.
There is no need to perform the genlock adjustment if the 
camera is not going to be synchronized with an external 
signal.

For details on genlock adjustments, refer to the operating 
instructions of the camera and cable compensation unit.

Operation