37 (E)
G/L SETTING (genlock adjustment)
menu
H PHASE (–206 to +49)
This item is used to adjust the horizontal phase during
genlock.
SC PHASE (1, 2, 3, 4, –511 to +511)
This item is used to adjust the colour phase during genlock.
CONTROLLER SETTING (controller
setting) menu
BUZZER SET (ON/OFF)
This is used to set the buzzer contained inside the control
panel to ON or OFF. The buzzer does not sound when OFF
is selected as this item’s setting.
At the ON setting, the buzzer sounds when the CALL button
is pressed and when a tracing memory operation (entry,
recall or change) has been started, suspended or data entry
has been completed.
EXT CONTROL OUT (ON/OFF)
When connecting the dial up adapter, it will be set to ON.
Set to OFF during normal use.
MEMORY LENGTH (30s, 60s, 150s, 300s)
This item is used to set the tracing memory entry time
(memory length) and number of memories.
30s : 30 seconds 10 memories
60s : 60 seconds 5 memories
150s : 150 seconds 2 memories
300s : 300 seconds 1 memory
If data has already been entered into a tracing memory,
the entry time and number of memories cannot be set.
Before entering different settings, delete the contents of
the tracing memory.
HEAD SW (R) FUNCTION (ON/OFF)
When ON is selected as this item’s setting, it is no longer
possible to switch the adjustment dial functions (IRIS and
FOCUS) using the button on the top surface of the PAN/TILT
lever.
Since it is not supported at the present time, select the OFF
setting for use.
VIRTUAL STUDIO MODE (ON/OFF)
When ON is selected as this item’s setting, the camera’s
video signals are switched to the corrected colour position
for using the blue background of the virtual studio.
Setting menus